Step1: Lay Bottom T-Bar in place,
and mark holes.
|
Step 2: Drill 9/32 Holes in Seat
Base.
|
Step 3: Mark center of seat, back
1 1/2 from front of rear seat.
|
Step
4: Stick Boot in place centered over mark you just made on your seat.
|
Step 5: With a long serrated knife
cut hole through Boot and Cover, 1 1/2 wide, into foam, clearing foam
from area where you just drilled in step 2. Boot will keep you from
cutting too wide.
|
Step 6: Slide Inside Bar into slit,
through Boot, into foam.
|
Step 7: Turn seat upside down.
Push down on seat compressing foam and line up holes through T-Bar, seat
base and inside bar. Insert bolts through lock washer, Bottom T-Bar,
seat base and into Inside Bar threaded holes and tighten.
|
Step 8: Install bar attached
to pad to tube now sticking out of seat. Slide in bolt furnished
and tighten bolts. Make tight enough that backrest will stay in place,
but will still hinge back and forth.
|
