UTOPIA BUILT-IN DRIVER BACKREST INSTALLATION INSTRUCTIONS
FOR All ROYAL STAR &
ROYAL STAR VENTURES

1) Remove front seat, leave passenger seat in place if you intend to leave on cycle,
if not remove before installing your new Utopia Driver Backrest bracket.


     
     
     

    2) Push out plastic rivets holding  plastic shroud to frame. 



      4) Slip your new Utopia Driver Backrest bracket between frame and fender, lining up with the two holes you just enlarged. 



    5) Insert bolts furnished into the two holes and tighten. 

 


 

Stick and Peel Boot above (prevents hinge from rubbing on rear seat)

3) Then drill out these holes 9/32” to 5/16”  through metal and plastic shroud (we’ve found some Royal Stars vary slightly, if holes do not line up, go to bigger bit and use flat washers with lock washers and bolts furnished).  Be careful to protect your fender, by laying something over fender in this area, in case you drill too far.  Plenty of room between frame and fender to stop in time, but play it safe. 


 
 
 
 
 
 
 

Top Bar 
Tube



6) Attach top bar (attached to pad) to tube at the top of Utopia Driver Backrest bracket, with bolt furnished.  Keep this bolt tight so it will stay where you position it. 
 

 

 7) Finally re-install your driver seat and adjust your new Utopia Driver Backrest to the
position most comfortable to you.  See adjustment instructions in picture below.